Over the weekend, I was able to finish cutting the metal for the frame as well as the polycarbonate. It took quite some time, but nevertheless I got it done. Below are a few picture of all the material.
I ran into a bit of a mishap with frame. When I was cutting, I did not take int account that the spacing of the holes depends on which side it will be located. For this reason, the welder did not get as much done as he had hoped. I fabricated a new piece and delivered it so he should be on his way.
I ran into a bit of a mishap with frame. When I was cutting, I did not take int account that the spacing of the holes depends on which side it will be located. For this reason, the welder did not get as much done as he had hoped. I fabricated a new piece and delivered it so he should be on his way.